KioskeaKioskeaCommentCaMarcheSign up, it's free !
Wednesday July 9, 2008 - 2:54:26 am BST
Cisco Router Help
par sharonstone
 Threaded discussions
Statut : Not resolved
Saturday April 19, 2008 05:24:16 PM
Hello,


Currently, we are running 2 domains - one for staff, and another for students. However, our Cisco Catalyst 2960 router has too many ports configured for the 'student' domain, and we have run out of staff ports.

My questions is, how can I reconfigure these ports so we can use the excess student ports as staff ports?

I have complete access to the router's OS, but I am not sure which options there-after I should be looking at.

Any help would be appreciated.
Configuration: Windows XP
Internet Explorer 6.0
Reply to sharonstone  Report this message to moderators Go to last message

1


  • This message seems useful, vote!
  • Report this message to moderators
By great_0, on Saturday April 19, 2008 05:56:14 PM Threaded discussions 
Hai

If you just need to change the vlan port assignments , logg into the 2960 , get into interface config mode for whatever interface you want to change then use the following command "switchport access vlan XX" where XX is the vlan number you want the port into , as previous poster said this is a layer 2 switch and not a router . This device cannot route any packets , the layer 3 function would have to done by an attached router or a layer2/3 switch .
   
Reply to great_0
Currently no message on this subject
Reply
Message title :
Your nick:
Your E-mail :
Message: 
  •  
  •  
Options: Get the answers by mail.
 

Help