Search : in
By :

Sata drivers

Last answer on Feb 18, 2009 8:23:03 am GMT AHMED, on Nov 23, 2008 4:39:47 am GMT 
 Report this message to moderators

Hello,
Can you send me the sata drivers please?? I cannot install the windows xp unless i have the sata drivers.
I CAN NOT INSTALL WINDOWS XP, THE HARD DID NOTAPEAR FROM CD BOOT

Configuration: Windows XP
Firefox 3.0.4

Best answers for « Sata drivers » in :
Formatting Your Hard Drive ShowFormatting Your Hard Drive Formatting and installing your Hard drive using the installation CD ] A hard disk drive is a non-volatile device mainly for data storage. Usually faster than any other storage device, this essential...
Installing Windows XP on a SATA hard drive ShowInstalling Windows XP on a SATA hard drive Motherboard Model Downloading SATA drivers Windows Installation With floppy Without floppy Another way You can install Windows XP on a SATA hard drive… It may not be easy as the system...
Downgrading from Windows Vista to Windows XP (HDD S-ATA not reco ShowDowngrading from Windows Vista to Windows XP (HDD S-ATA not recognized) The necessary tools Step 1 Step 2 Step 3 - Download Nlite Step 4 Here is the method (yes, I wanted to put XP on my HP laptop and I really hard and now it...
Serial ATA (SATA or S-ATA) ShowIntroduction The Serial ATA standard (S-ATA or SATA) is a standard bus allowing high-speed storage peripherals to be connected to PC computers. The Serial ATA standard was introduced in February 2003 in order to compensate for limitations of the...
ATA, IDE and EIDE ShowOverview The ATA (Advanced Technology Attachment) standard is a standard interface that allows you to connect storage peripherals to PC computers. The ATA standard was developed on May 12, 1994 by the ANSI (document X3.221-1994). Despite the...
PCI Bus ShowThe PCI Bus The PCI bus (Peripheral Component Interconnect) was developed by Intel on 22 June 1992. Contrary to the VLB bus, it is not so much a traditional local bus but rather an intermediate bus located between the processor bus (NorthBridge)...
Ask your question Reply

1

beachpoet, on Nov 23, 2008 4:47:16 am GMT

There are no drivers unless you are using a raid drive setup.

Your problem is that the drive isn't plugged in. Go back and push the connector in very hard, it should make a very slight click. Then pull on the cable. If it just slides out, get another cable. Do this to the mobo and the drive..

If this isn't your problem, then go into the cmos and make sure it's set properly, if it is set to boot on the Pata drive, you have to switch over to SATA.

   
Reply to beachpoet

4

gambit, on Jan 29, 2009 4:07:18 am GMT
  • +5

To install Xp on a computer with a Sata hard disk you need the drivers provided with your motherboard. When entering the set up, a message will apppear asking you to press F6 if you need to installa SATA drivers. This is usually done using a floppy disk

   
Reply to gambit

2

yogui7, on Nov 23, 2008 3:24:53 pm GMT

Satas' cable should be plugged in the right order...so if your hard drive is the only sata product in your pc plug it in sata port 1

   
Reply to yogui7

3

ajay, on Jan 27, 2009 7:37:30 pm GMT

Please seend

   
Reply to ajay

5

ardeshir, on Jan 29, 2009 6:31:13 am GMT
  • +1

Hello
Can you send me the sata drivers please?? I cannot install the windows xp unless i have the sata drivers.
I CAN NOT INSTALL WINDOWS XP, THE HARD DID NOTAPEAR FROM CD BOOT.thanks

   
Reply to ardeshir

6

 Brian, on Feb 18, 2009 8:23:03 am GMT

If you guys knew anything about what's going on, you'd know that it's not a 'cable issue' or other bs.

The SB700 is the SATA controller that HP uses in their laptops. Which come pre-installed with Vista. In which HP provides literally NO support for installing XP on.

There's people out there that have actually succeeded in installing XP on these laptops, but it's hard as !#@$!@ to get everything you need to do so.

   
Reply to Brian
Ask your question Reply
They need your help