Search : in
By :

HP Compaq CQ-50(vista)..DHCP network adapter

Last answer on Oct 28, 2009 1:56:53 pm GMT trabo, on Oct 27, 2009 11:55:07 pm GMT 
 Report this message to moderators

Hello,
hi..i tried to connect to internet via any means possible (wireless,wifi,broadband,LAN.etc...)..and i can't get through..i've tried to diagnose it..the problem still exist..unidentified access @ local only.it state that something was wrong with my DHCP network adapter or so.the IP is in automatic mode..thanks

Configuration: Windows vista
HP Compaq CQ-50
AMD Athlon

Best answers for « HP Compaq CQ 50(vista)..DHCP network adapter » in :
[Windows XP] Repairing the network connection using command line Show[Windows XP] Repairing the network connection using command lines Under Windows XP there is a small feature allowing you to repair a network connection. Go to the Network Connections options in Control panel (Control Panel / Network...
[Linux]Restarting the network interface using command lines Show[Linux]Restarting the network interface using command lines When setting up a network, specially if you need to verify that a DHCP server assigns IP addresses correctly, restarting the network interface using command lines rather than the...
Download Realtek Wireless drivers for XP (RTL8187) ShowRealtek RTL8187 Wireless 802.11g 54Mbps USB 2.0 Network Adapter SITECOM WL-168 Wireless Network USB Adapter 54g SURECOM EP-9001-g 802.11g 54M WLAN USB Adapter
Download Disk Recovery Wizard ShowDisk Recovery Wizard is a tool to backup data. It allows to restore the damaged, corrupt and inaccessible data on a hard disk and even the formatting. A wizard guides you step by step to facilitate the operations. Disk Recovery Wizard supports any...
Download Softperfect Network Scanner Show
Installing a network adapter ShowPurpose The purpose of this article is to set up a network to enable data exchanges between computers, resource sharing and network games. Is it therefore necessary to install a network card in each computer that may be part of the local area...
Wi-Fi wireless network security (802.11 or WiFi) ShowAdapted infrastructure The first thing to do when a wireless network is installed is to place the access points in reasonable locations depending on the desired area of coverage. However, it is not uncommon to find that the covered area ends up...
Ask your question Reply

1

 dancedhall, on Oct 28, 2009 1:56:53 pm GMT

Hi there,

if you recently installed windows

you must install the drivers for it to

perform correctly , check your modem/router first

if its functioning correctly ,

are there other pc connected to the same network?

try to renew your ip address in command mode

by typing ipconfig/release followed

by ipconfig/flushdns and ipconfig/renew

Thanks

   
Reply to dancedhall
Ask your question Reply
They need your help