Configuration: Windows XP Firefox 2.0.0.14
u will have a jumper beside of the connector in hard disk,,u have to change its config,,,,,,,,,,u can get details from the lable on the hard disk,,u set jumpers according to lable given on hard disks ,,,definetly u can use your second hard disk,, |
|
Hello
If you put two devices on the same IDE cable/channel, one must be designated as master & the other as slave. There are small jumper caps on the rear of the drives that must be set appropriately. There's *usually* a diagram on the label showing the jumper setttings, or the pins may simply be labled MA (master), SL (slave) or CS (cable select). If you use cable select, both devices need to be set to CS, then the position on the cable determines which is master & which is slave. The device connected to the center plug is slave, the device on the end plug would be |
Résultats pour Making Master and slave HD
Résultats pour Making Master and slave HD
Résultats pour Making Master and slave HD
Résultats pour Making Master and slave HD
Résultats pour Making Master and slave HD
Résultats pour Making Master and slave HD