Search : in
By :

IP address static I can't access internet

Last answer on Jun 15, 2009 8:52:21 am BST Dutch67, on Jun 14, 2009 10:09:53 pm BST 
 Report this message to moderators

Hello,

I recently had to to change my IP address to static to allow another user on my workgroup access a shared file. Since doing so I can no longer access the internet. I am on XP home and Exploer 7.
I am sure that there is a simple answer to this but I am baffled.
Any suggestions?

Configuration: Windows XP Internet Explorer 7.0

Best answers for « IP address static I can't access internet » in :
Having a static IP address under Ubuntu 8.10 ShowHaving a static IP address under Ubuntu 8.10 To have a fixed IP persistent: Configure manually the interfaces For a fix IP (10.0.0.1 on your eth1 interface) use: To make use of dynamic IP (e.g eth0): DNS NetworkManager is a...
Command to detect your IP address! ShowCommand to detect your IP address! Command for Windows 2000 / XP / Vista Command for Windows 95/98 Command for Linux IP address (Internet Protocol) is a numerical identification to detect your computer on a network. It is used to...
Renew your IP address ShowRenew your IP address Issue Solution Issue Sometimes you are unable to access the internet even the LAN cable is connected and the router is running normally! You can also get this "Limited or no connectivity" which will appear on...
IP Address ShowWhat is an IP address? Computers communicate over the Internet using the IP protocol (Internet Protocol), which uses numerical addresses, called IP addresses, made up of four whole numbers (4 bytes) between 0 and 255 and written in the format...
IP address spoofing ShowIP address spoofing "IP address spoofing" is a technique that involves replacing the IP address of an IP packet's sender with another machine's IP address. This technique lets a pirate send packets anonymously. It is not a question of changing the...
NAT- Network address translation, port forwarding and port trigg ShowThe principle of NAT Network address translation or NAT was developed in order to respond to the shortage of IP addresses with IPv4 protocol (in time the IPv6 protocol will respond to this problem). In fact, in IPv4 addressing the number of...

1

 hrcomeback, on Jun 15, 2009 8:52:21 am BST
  • +1

Hi,

you need to renew the ip address.

go to start menu > run

type cmd and hit enter

then type ipconfig/renew and press enter.

your ip would be renewed and you should be able to access internet.

Reply to hrcomeback