When preparing to build a PC make sure to have the following: a phillips screwdriver, the necessary screws and the various cables and connectors.
There are some simple guidelines that should be followed:
Firstly we must fully open up the casing, then place it flat on a large surface with enough space to work comfortably, finally remove all plastic blanks from the drive bays at the front of the computer.
![]() |
Note: A case usually comes with a power cable and a set of screws. Screws with a fine thread pitch are normally used for floppy disk drives and CD-ROM drives. The more coarsely-threaded screws are used for attaching hard drives. |
Résultats pour PC Assembly Getting the case ready
Résultats pour PC Assembly Getting the case ready
Résultats pour PC Assembly Getting the case ready
Résultats pour PC Assembly Getting the case ready
Résultats pour PC Assembly Getting the case ready